Low Power Loads

Shown below are the two types of low power loads. These are constructed from either pre-machined ceramic or carbonyl iron loaded inserts or silicone rubber moulded inserts depending on size and specification.
The precision loads also employ a technique of moulding the load material in the housing to achieve the best possible V.S.W.R.
Detailed below in a generic table, most of this type of load is application specific.

Note: precision loads normally in brass.
* there is an important trade off between performance and cost. Please specify your requirements in detail to obtain an optimum solution. Many high performance models are available and the physical size can also be altered to suit your requirements.